Computer Numerical Control CSC
The template below is for students declaring a major for the catalog year 2018-19. The Advising Sheet Archive contains printable advising sheets for the catalog years 2016-17, 2017-18, and 2018-19. Students already with a declared major should view their advising report in SIS for appropriate course selection.
Career Studies Certificate (CSC)
Career & technical education programs for job training
= Career & technical education programs for job training, guided by Advisory Committees
N Majors not eligible for financial aid = Majors not eligible for financial aid
To provide students with numerical control techniques in metal forming and machine processes.
Program Requirements and Special Conditions
Students must meet JTCC admission requirements. New students should visit the Advising Center and returning students their faculty advisor for more information.
|Required Courses||CR.||Pre-requisite Courses||Approved Course Substitutions|
|MAC 181 Machine Blueprint Reading I||3|
|MAC 121 Computer Numerical Control I Offered Spring Only||3|
|MAC 122 Computer Numerical Control II Offered Fall Only||3||MAC 121|
|MAC 123 Computer Numerical Control III Offered Spring Only||3||MAC 121 & MAC 122|
|MAC 130 Introduction to Electric Discharge Machining (EDM)||2||MAC 121|
|MAC 134 CMM Operation and Programming||2||MAC 121|
|MAC 150 Introduction to Computer-Aided Manufacturing||3||MAC 121|
|Total Minimum Credits to Complete||19|
- Students should regularly meet with their faculty advisor and check their advisement report in MyTyler – SIS.
- Courses noted as Fall only or Spring only are based on historical trends and current planning and may change without notice.
Your Right to Know
The State Council of Higher Education for Virginia requires colleges to provide information on graduation rates. The U.S. Department of Education requires colleges to publish gainful employment consumer information for career/technical programs.